[. . . ]
To prevent you from being exposed to risks, vacuum cleaner repairs and the fitting of replacement parts must only be carried out by the authorised after-sales service.
The vacuum cleaner should be protected from the weather, moisture and sources of heat.
At the end of its life, the vacuum cleaner should be disposed of in an appropriate manner.
For safety reasons, vacuum cleaners with a power rating of more than 2000 W are fitted with a temperature safety switch which automatically switches the vacuum cleaner off if it is blocked and overheating. [. . . ] If a fuse is be tripped when you switch on the vacuum cleaner, this may be because other electrical appliances which have a high current draw are connected to the same power circuit. To prevent the fuse from tripping, select the lowest power setting before switching the vacuum cleaner on, and increase the power only once it is running. 2006
11:12 Uhr
Seite 10
en
Figure 7 Holding the power cord by the plug, pull out the required length and plug it into the mains socket. Figure 8 Press the on/off button in the direction of the arrow to switch your vacuum cleaner on/off. Figure 9 Adjust the suction by turning the on/off button in the direction of the arrow. Depending on the surface of the wall to be drilled it may be necessary to readjust the power to a higher setting to ensure the drill dust nozzle is firmly attached. Caution: The drill dust nozzle should only be used in conjunction with the dust collector since fine drill dust can impair the function of the dust bag. Vacuuming
Figure 10 Adjusting the floor tool: a) Rugs and carpets b) Hard floors Figure 11* Vacuuming using the accessories (if required, connect them to the handle or the suction pipe). Figure 12* Ⅲ Secure the drill dust nozzle to the handle and then place against the wall, so that the nozzle drill hole opening sits directly over the hole to be drilled.
Select the lowest power setting and then switch on the vacuum cleaner. Figure 13 You can use the parking aid on the back of the vacuum cleaner if you wish to stop vacuuming for a short time. Slide the catch on the floor tool into the groove at the rear of the appliance. Figure 14 The appliance can also be carried using the two handles when vacuuming steps, for example. Figure 16 To store or transport the vacuum cleaner, use the storage aid on the underside of the vacuum cleaner. Slide the catch on the floor tool into the groove on the underside of the appliance. You have purchased a floor vacuum cleaner which can vacuum up any type of dry dirt using the dust collector or dust bag. We recommend that you use: - the dust collector, in particular for your hobbies, e. 2006
11:12 Uhr
Seite 11
en
Using the dust collector
Figure 17 Set the power setting to maximum for the best results when vacuuming. We recommend that you reduce the setting only when vacuuming very delicate materials. Cleaning the permanent filters and micro filters in the dust container
The filters must be cleaned: Ⅲ After any operating malfunctions, i. Figure 22 Ⅲ Press the fastener on the rear side of the container and remove the micro filter from the bottom of the container.
Remove the permanent filter from the bottom plate of the container. [. . . ]
After cleaning, slide the motor protection filter into the vacuum cleaner and close the dust bag compartment lid. Care
Always switch off the vacuum cleaner and disconnect the power cord from the mains before cleaning the appliance. The vacuum cleaner and plastic accessories can be cleaned with a commercial plastic cleaner. Replacing the dust bag
Figure 26 Ⅲ If suction diminishes considerably, the dust bag must be replaced, even if it is not yet full. [. . . ]